Transparent canvas, wormhole to Rhino Viewport.

In the previous version was using a panel component to set the wormhole, which was quite annoying. This time the canvas itself is used, so that we can move the canvas to any part of our definition that the hole will be there. Besides, the wires are above the window.

This open script in VB lets you set a transparent background and interact with Rhinoceros without minimizing the GH interface.

Wormhole.gh

Sets a boolean to activate it and a number (between 0 and 1) to adjust the width. However, I have not managed to change the width while the hole is active, so if you want to change the width, you will have to disable it. Any improvement on this is welcome.

It is known that monitors longer than 24 bits of color depth, clicks on transparency does not affect in the interface behind. If so just have a transparent window. See here.

Enjoy the holidays.

Next Post >

Comment

You need to be a member of Grasshopper to add comments!

Comment by Kathryn M. Rivera on February 8, 2022 at 2:41am: Hello, Daniel. I like it as a component. Take a peek at this page if you're looking for a photo booth to rent in New York. When you collaborate with this page, they handle everything so you can concentrate on your guests. Their large selection of photo props will ensure that your event is remembered for weeks.

Comment by Congzheng ZOU on February 3, 2020 at 8:51am: Six years after

Comment by Daniel González Abalde on September 21, 2016 at 7:23am: Thanks all,

@Tim, you need to create an UserObject and you can add it to the category/subcategory you prefer.

Comment by Tim on September 21, 2016 at 6:00am: Hi, Daniel, nice component, I like it. Are you familiar with OnTopReplica, check it out if you need new ideas for the tool. I wonder, how do you add it to Util panel?