Grasshopper

algorithmic modeling for Rhino

Component for removing duplicate Curves.

Check this page for download (in order to download the component, you need to join the Milkbox group first!).

Views: 8414

Comment

You need to be a member of Grasshopper to add comments!

Comment by djordje on December 1, 2017 at 12:52pm

Thank you for the reply Nick.

Comment by Nick Dodge on December 1, 2017 at 12:16pm

I simply needed to restart the program....

Comment by djordje on December 1, 2017 at 11:58am
Hi Nick,
Can you just comment on what caused the issue?
Was the .ghuser file blocked?
Comment by Nick Dodge on December 1, 2017 at 6:26am

It is working now! Thanks for the help!

Comment by djordje on November 30, 2017 at 11:12pm

Hi Nick,
What are your Rhino, Grasshopper and ghpython?
Did you check if the userobject isn't blocked? (Right click on it, then if the "Block" is present click on it in the lower right corner, click on "OK, and restart Rhino).

Comment by Nick Dodge on November 30, 2017 at 3:13pm

I keep getting this message when I add your component to my script. Is there any easy fix? 

Comment by Michèle Dossmann on December 18, 2016 at 8:06am

Hi Djordje,

Sorry for my last post, everything is ok with your component, there is a problem with my inputs! I have to review my previous inputs. Many thanks for your contribution! You solved a big part of my problem!

Comment by djordje on December 18, 2016 at 4:55am

Hi Michèle,
The step of having to join the Milkbox group before being able to access the download page was not mentioned. It was my mistake for not stating this in the first place. Sorry about that. I added it now.

As for the issue that you are currently having, you can open a new topic in the discussions forum. I will see it, and take a look at your files.

Comment by Michèle Dossmann on December 18, 2016 at 3:08am

Hi Djordje,

Many thanks for your help. Now I have solved the problem. I missed a few steps like joining the milkbox group so I couldn't load the .3dm and gh file to see your examle this. Almost all is fixed now. 

I say "almost" because I have like a "bug" using your component. But I can't attache a file here so I sent you an invitation to be able to do it through the add button on top of this page. Sorry, as I am a newcomer on this pages I need to progress  in using the site too. :-)

Comment by djordje on December 17, 2016 at 11:28am

Hi Michèle,

To download this component you need to be a member of the Milkbox group first.
If you are not, then go to this page, and click on "+Join Milkbox".

After that you can access component's download page.
Download and open the "remove_duplicate_curves.gh" and "remove_duplicate_curves.3dm" files from that page. The "remove_duplicate_curves.gh" file should contain only a single "Remove duplicate curves" component. No other components are located in that .gh file.


You mentioned:

"I downloaded the .ghuser file bur cannot find the other two to load the script."

Which other two .ghuser files?

About

Translate

Search

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service