Looping List

Hi All,

Sorry if this is too basic, I am sure this has been answered somewhere else somehow I wasnt able to find it...

I have a set of objects (surfaces) which I want to extrude using a list of values. There are more objects than values in the list and I would like the operator to go back to the begining of the list until there are no more objects to extrude. Normally grasshopper just repeats the last value for the remaining objects. Is there a way whithin gh to make this loop? How do I set up the condition and do I need an additional plug-in (hoopsnake)?

Thank you in advance,

HowToLoopAList.gh

Comment

You need to be a member of Grasshopper to add comments!

Comment by Rolando Rodriguez-Leal on September 12, 2015 at 3:30am: Thanks David,

I have reposted here

http://www.grasshopper3d.com/forum/topics/how-to-loop-a-list

Comment by David Rutten on September 11, 2015 at 1:34pm: You should add a discussion in the forum rather than a personal blog post. Few people will see this.