September 2015 Blog Posts (7)

Metaball manifold meshes

Could be interesting to see this combined with Stasiuk's Cocoon in a 3D-print case-story (Arthur?)
Would it be possible to get a short description of the 'negative influence'=How to make the metaballs behave in a way where it does the opposite than attract each other? (David?)

Added by Tim Nøhr Elkær on September 29, 2015 at 1:14pm — 2 Comments

Refugees Welcome House

Continue

Added by Dimitry A. Demin on September 21, 2015 at 4:25am — 1 Comment

sky type and render

Hi:

I have started honey bee.so here some problems that I encounter with them.

the first one is :what are the differences between "climate based sky","standard CIE sky","cumulative sky" and "average sky"?

the second one is:what are the each sky type definition exactly?(sunny with sun,sunny without sun,intermediate with sun,....)

finally,in image based analysis,when I render from my building,can I have this rendering as a picture outside the grasshopper?if yes,how…

Continue

Added by sajad shahin on September 19, 2015 at 1:14pm — 3 Comments

LADYBUG SUNLIGHT ANALYSIS

Hi Mostapha, hi all,

I'm becoming a frequent user of LadyBug and first of all I thank Mostapha for the amazing tool you provided to all of us!

I'm running some analysis for outdoor spaces comfort and I need to get average values of Sunlight Hours during different analysis periods. Ladybug Sunlight Hours Analysis provides the sum of each daily values, is there a way to get an average value for the overall analysis period instead?

Thank you in…

Continue

Added by Andrea Rossi on September 18, 2015 at 10:30am — 3 Comments

Grasshopper Developer Needed

Simbiotek Design Lab is looking for an experienced Grasshopper Developer to create a new plug-in. This plug-in's purpose is to actuate a series of mechanical pins for the purpose of creating pre-cast architectural panels in an industrial setting. The intent is to hire by contract for a feasibility study that may lead to a full time position based on performance. The first task is to complete cost estimate for the development of this plug-in.

Plug-in specs:

-…

Continue

Added by Hunter Ruthrauff on September 14, 2015 at 9:57pm — 6 Comments

Continue

Added by braulio gatica on September 11, 2015 at 8:33pm — 1 Comment

Looping List

Hi All,

Sorry if this is too basic, I am sure this has been answered somewhere else somehow I wasnt able to find it...

I have a set of objects (surfaces) which I want to extrude using a list of values. There are more objects than values in the list and I would like the operator to go back to the begining of the list until there are no more objects to extrude. Normally grasshopper just repeats the last value for the remaining objects. Is there a way whithin gh to…

Continue

Added by Rolando Rodriguez-Leal on September 11, 2015 at 12:18pm — 3 Comments