Workshop Book_Page_43

Comment

Comment by Roland D. Sandoval on September 10, 2011 at 8:06pm

Hello Mauro,

 

I wander if you can help me out a little bit, since the geometry I am working on is very similar to what you show in this pic.

 

I have a bunch of circles with varying in radii, projected onto a surface, (I couldn't even trim or split this circles from the surface, as a first try) this surface has a thickness (then, is a closed polysurface) So, I want to create "tappered" holes in it. In order to achieve this, I am extruding those circles to a point and I get some open "cones", and is right there where I cannot make a solid difference or any other method that allows me to do the boolean operations.

 

I really appreciate if you can give me a clue about how you did it, if I have been explicit enough.

 

Greetings!!!