View 1

Comment

Comment by Ignacio on May 25, 2010 at 2:35pm

Thanks for your help Tyler Zalmanzig!!!

Comment by cmrhm on May 25, 2010 at 1:37pm

Nice!

Comment by Tyler Zalmanzig on March 15, 2010 at 10:14pm

The corner is something that I also struggled with. Honestly, I don't think it can be solved once you add a thickness to it. The geometry never seemed to work unless you made all turns parallel with the ground plane.

If you are looking for something that is not structural and is just a graphic of some kind. The way i did that was, Create a voronoi pattern the length of your building and bake it and Use the split tool to create 4 different sections. and then i wrapped them around the building. I'm not sure if that was the best way to do it but it was all that i could do. Hope that helps some.

Comment by Ignacio on March 10, 2010 at 2:22pm

Hello!! I'm trying to do something similar in grasshopper, but I can't make a good voronoi that has a corner between two surfaces like this picture. Can you help me? this is what i get: