algorithmic modeling for Rhino
Comment
Hey Paco! Very nice definition! :) do you know if its also possible to define the positions of the columns more precisely than to postion them by the sliders?
kind regards
Lee
Sorry I didn´t meant to post it as my work, i will post the source when I use one, you are right Michael, my bad.
:))) Well it is meant to be copied. But when you post it as "your" work and then send screenshots of "your" gh instead of the link you copied from. Its like come on......... lol
Come on Michael, not only has an extra 'bridge' been added, but he has clearly got rid of those pesky group boxes...
Next time you should site your source, especially when looking at your screenshot you just fully copied it ;)
http://formularch.blogspot.com/2012/05/gh-surface-bridging.html
Hi Paco
Sent you a message!
I was in the north of sweden. No computers no cellphone only reindeers on the road!!
Best regards
Per
sorry man!!! i've been busy, but give me your e-mail and i will send you my definition.
ahhh, thanks for that...
But tried it and that did not do the trick, is there something about how I select the surfaces? I use "Set Multiple Surfaces" (reference mode). Because I can switch to either have the upper or the lower surface doing the lofting by selecting the one after the other. But I cant get them to both loft at the same time though.
So any other ideas? And thanks for keeping up with me, I am a newbie at GH... maybe its obvious.
Best regards
Per
check the second weave component, the one before the highlighted loft. That one is the problem, you have to switch to GRAFT the "2" in the component.
Welcome to
Grasshopper
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
© 2025 Created by Scott Davidson.
Powered by
You need to be a member of Grasshopper to add comments!