Serpentine_001

Comment

Comment by arcra on April 20, 2011 at 7:45am

Thanks! I will keep it in mind!

Comment by Ángel Linares on April 20, 2011 at 5:01am

Be carefull about the position of anchor points, it must be over a point in the mesh and then you must click on reset. I've only used the examples from Daniel Picker and modified it to fit the model i would like to have (new components to control deformation, units tweeck, some control geometry to generate the mesh using pedestrian paths and other stuff, etc.)...

Comment by arcra on April 16, 2011 at 4:47am

Hi, I love this work... I just started using Kangaroo, but a bit lost. Did you achieve this by adding PLaw as the force? I keep getting an error message saying index is out of range.

Will you be able to give me some insight into this?

Thanks in advance!

Comment by Arthur Mamou-Mani on October 21, 2010 at 3:56am

Very nice. I like the physical model render :)
Any chance you could share the definition ?
It d be great to see how you used both tools...

Comment by Adam Chałupski on October 21, 2010 at 3:26am

really nice effect of using Kangaroo and how natural forces can be use to form the object.
Good job !

Comment by Ángel Linares on October 19, 2010 at 5:40am

Hi!, Thanks!

It's a mesh surface. I use points to keep geometry controlled (Cull faces to make holes, keep surface on the floor in some points...) but not using mesh points.

It´s like Gaudi stuff but using Kangaroo to simulate.

Comment by Jerrimo on October 19, 2010 at 2:20am

Fantastic!! But i still can´t imagin how you created this beautiful surface with all these nice tools. Did you used any curves or have you done the surfase only by points?
I´m looking forward to see more of such a fantastic work.