Grasshopper

algorithmic modeling for Rhino

Selkie bangle 3D prints

Selkie bangle 3D prints

This is an old definition, but still interesting note the 'flipped' taper version in the centre, with an elongated ripple texture.
It contains both a complete parametric description of a bangle design (including a parametrically variable rippled outer surface) AND all the tweaks and optimisations which were required to get it to print, in ABS, on a RepRapPro Huxley FDM printer without warping off the bed or requiring more than minimal cleaning up afterwards. I'm working on an updated version, to be printed in PLA, on a Fisher Delta...

Views: 183

View Full Size

Comment

You need to be a member of Grasshopper to add comments!

Comment by Dr Gareth Paterson on November 12, 2017 at 2:26am

Thanks, Wieland - good to hear from you again :-)

I've been back from Cairo for a while. These are so old that they were actually part of my portfolio when I applied for the job at the GUC...

Comment by Wieland Schmidt on November 10, 2017 at 3:01am

Nice work, Gareth! Are you still in Cairo?

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service