algorithmic modeling for Rhino
section table
Comment
-
Comment by Alex Bahrami on December 21, 2010 at 2:53pm
-
Thx and have a good time.
Regards
Alex
-
Comment by giac0mo on December 21, 2010 at 5:12am
-
just dividing a plane in points, pushing some points to get the feet and then make curve pass trough new set of point...then offset and plane surface to extrude...
-
-
It's very nice! Can you give me a hint how you get it?
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
-
Voronoi Facade
Added by Parametric House 0 Comments 0 Likes
-
Weave Mesh
Added by Parametric House 0 Comments 0 Likes
-
Pathway Frames
Added by Parametric House 0 Comments 0 Likes
-
Contour Chair
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson.
Powered by
You need to be a member of Grasshopper to add comments!