SEAT

Comment

Comment by Yong Ju Lee on August 22, 2012 at 12:33pm

no problem.

Comment by djordje on August 22, 2012 at 2:53am

I realize that now.
Thank you Young.

Comment by Yong Ju Lee on August 21, 2012 at 11:03pm

As you can see here, because of slope direction, they don't touch each other in GROUP C, if all the chairs face to the right. To make the vortex, chairs should face to the center. The image below is the old plan showing that rotation.

Comment by djordje on August 21, 2012 at 6:17am

Thank you for the reply Young.
But I am not sure I understood you. Your chairs are placed sequentially and gradually one behind another with each one lowered of raised in height in comparison to the previous chair. So they always remain in the vertical position?
So where is the rotation of the chairs?

Sorry for disturbance.

Comment by Yong Ju Lee on August 20, 2012 at 11:09pm

and thanks,

Comment by Yong Ju Lee on August 20, 2012 at 11:08pm

Those arrows are normal vectors of the base surface to make the chairs rotated to follow the slope. Because of chair shape, if they are arrayed in one direction, they don't touch each other in a certain slope. so those arrows decide the rotation angle of chairs.(0,90,180,270) 

Comment by djordje on August 20, 2012 at 12:31pm

Than that makes the project even harder and better!
Great stuff !!

Hope to see some more cool things from you :)

btw what do those vector arrow represent?

Comment by Yong Ju Lee on August 20, 2012 at 11:45am

I didn't use kangaroo at all. Everything is done in plain GH.

Comment by djordje on August 20, 2012 at 4:55am

Did you use kangaroo, or just plain GH code?