test07

Comment

Comment by Robert Beach on December 6, 2010 at 6:58am

I create Isocurves at a slope(v/u) making a set of parallel curves on the surface. I then subdivide the curves into segments and connect the subdivision points with a polyline. I then extrude the polyline to create planar surfaces intersecting with the input surface, one for each segment in the polyline. Finally, I intersect the planar surface with the input surface to produce the curves. I then filter out any curves from this set which intersect.

Comment by Mirco Bianchini on December 5, 2010 at 6:34am

Hi, it's very interesting
how do you do that?
Can I look at your definition?