PUNCH CHAIR_GIUSEPPE CARBE'

Comment

Comment by Giuseppe Carbè on October 19, 2013 at 6:15am

Thaks Jeremy! Fore the definition of the final form I have used T-Splines, a very useful plugin for Rhino that works look like 3ds max or Maya. It's very good to modeling 'cause works very good  with the mesh instead Rhino. Only after I've used Gh to the definition of the slices. 

Comment by Jeremy on October 18, 2013 at 9:09pm

Really cool work! I've been a little bit idle with my grasshopper work recently and I'm just trying to figure out how you went about generating the basic form? Did you start off with a sphere and then do what to it? 

Comment by Giuseppe Carbè on October 8, 2013 at 4:21am

Yes shoud be possible but it would go against the logic of the materiality of the chair.

Be careful to eat 'cause the carbord is not very digestible! ;)

Comment by martyn hogg on October 8, 2013 at 3:23am

Looks good enough to eat!

How about padded cushions inside each waffle hole to make it comfortable? :)