Master Thesis Project

Comment

Comment by Libor Mladek on December 18, 2014 at 2:28pm

Hi, any more information about that project?

Comment by Brian on March 30, 2013 at 2:28pm

Do you have a definition for the expanded metal? I've been trying to do something similar but cannot figure out hot to get that skin quality.

Comment by Yuta Ito on April 7, 2012 at 9:46am

Hi, Andres. Thank you for commenting and inviting me to RhinoFabLab. Let me join!

Comment by Yuta Ito on April 7, 2012 at 9:46am

Hi Angel, thank you for posting. yes, your suppose is right. I cut the metal sheets by plasma, however for deformation I just pull only one load point on a metal sheet vertically with load experiment machine. 4 different results are coming from different load point on each.

Comment by Andres Gonzalez on April 7, 2012 at 9:30am

Very nice!

Comment by Ángel Linares on April 7, 2012 at 5:47am

Nice research! keep posting results! Which technics are you using to push the metal sheet? I supose that you cut it with sand/plasma/etc, and then use some kind of milled form to push the metal sheet to the correct deformation state.