algorithmic modeling for Rhino
octahedra_grid
The picture shows a boxshaped volume that consists of three- dimensionally stacked truncated ocathdrea. Each of the individual modules has its own degree of elasticity assigned, that will be later produced wih the help of layered fabrication.
The FE based deformation diagram has been converted into a selection pattern for the individual material properties.GH was used for the morphing process of the spacefilling module.
Comment
-
Comment by Norbert Palz on July 1, 2009 at 2:33am
-
hi andrew,
to get the information from the FE software is a bit of work and not really elegant. i am sectioning the 3D performance diagram into horizontal plates with their specific analysis information.from that i generate a selection matrix in paracloud, that gives me points for 6 layers of material specification. these points are then used to boxmorph the octahedron into place. it is a bit laborious but i am looking for a more smooth way.
-
Comment by Andrew Lyon on June 30, 2009 at 12:38pm
-
That's really cool how did you interact with the FE software an
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
-
Orient On Curve
Added by Parametric House 0 Comments 0 Likes
-
Parametric Roof
Added by Parametric House 0 Comments 0 Likes
© 2025 Created by Scott Davidson.
Powered by
You need to be a member of Grasshopper to add comments!