NEW_gRadFAB

Good news, bad news...

The radial grillage fabrication utility is as finished as it's going to be for while, but sometimes it locates notches on the wrong edge.

For the vertical sections in this example (it might be too tiny to see clearly) all the notches should be located on the vertical edge.

If you use the definition, check any output for vertical ribs. The notches will be the correct length, but each notch might need to be mirrored vertically about itself. The notches can be trimmed out with the older stand-alone gFAB_trimSections.ghx definition.

I'll fix the problem when I get a chance...