algorithmic modeling for Rhino
Hardware Remote Control v2
Hardware "sliders" (knobs) for Grasshopper. Arduino board inside. See this post for more info: (http://www.grasshopper3d.com/photo/hardware-remote-control-in-gh). Firefly connects between arduino and GH. The grey plastic case is 14 x 11 cm.
Tomasz Gancarczyk made one too: http://www.grasshopper3d.com/photo/knob-controller
and so did bingg http://www.grasshopper3d.com/photo/arduino-in-use
Albums: FFAR Exhibition Opening
Location: Stockholm
Comment
-
Comment by Mårten Nettelbladt on February 11, 2011 at 6:03am
-
Thanks guys.
It's a mess inside, I can assure you. In fact all the wires turned out to be a perfect cushioning to the arduino board, I could barely sqeeze it all in and tighten the screws...
-
Comment by John Fredrickson on February 10, 2011 at 8:27pm
-
Nice! I like it w/ the exposed wiring better though...
-
Comment by Tuan N. Tran on February 10, 2011 at 6:31pm
-
nicely done marten.
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
-
Voronoi Facade
Added by Parametric House 0 Comments 0 Likes
-
Weave Mesh
Added by Parametric House 0 Comments 0 Likes
-
Pathway Frames
Added by Parametric House 0 Comments 0 Likes
-
Contour Chair
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson.
Powered by
You need to be a member of Grasshopper to add comments!