Grasshopper

algorithmic modeling for Rhino

hauer_drillcycles4

hauer_drillcycles4

This one worked well. Here I am using a 1.25" bowl cutter style endmill and I am running it to a depth of .07" at an interval of 1.5".

Views: 241

View Full Size

Albums: Hauer Style Drill Patterns

Comment

You need to be a member of Grasshopper to add comments!

Comment by machinehistories on December 3, 2010 at 6:39pm
yeah that's pretty much it. I ran the drill cycle on a given grid with a shaped endmill. I then flipped the sheet and drilled the other side using a grid which was transformed 1/2 the x y spacing of the grid. - thanks
Comment by Mehmet Ali on December 3, 2010 at 6:08am
Excuse me for a very beginners question. Is the process how I imagined? : You have made a grid and at each intersceting point you made a hole to a thick material after all holes have been made you turned the material to other side and you aligned the material and made the hole just by positioning the material to the unholed grids. Is it correct? Fascineting work..

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service