cellular_voronoi

Comment

Comment by Gstei on October 21, 2012 at 4:36am

Thanks a lot!!

Comment by Mauricio P. Montalvo on October 20, 2012 at 12:18pm

the component that u use to create the surface, "surface" .
will make all surfaces of all curves.
but the "planar srf" works like the command "_planarsrf" of rhino.
all curves that are incorpored in between others, it makes u the area between that curves.
that's just another way without occupy so much memory, thus avoiding those red or orange messages on the definition.

weave component from Mauricio on Vimeo.

Comment by Gstei on October 20, 2012 at 4:22am

Hi Mauricio,

I tried to do it your way (I would have used surface split component), but I obtain only the surfaces of polygons and the curves mixed, not the main surface with holes. See attached

Thanks for the answer

Comment by Mauricio P. Montalvo on October 19, 2012 at 11:04pm

HI Gstei.
does not replace it, is another method of arriving at the final answer using less memory. because Boolean operations take longer in grasshopper, in this case the surface is small, but if it were larger with many piercings take longer. greetings :)

Comment by Gstei on October 19, 2012 at 4:51am

Dumb question: How the weave component can replace the solid difference?

Comment by Behnood Eghbali on October 19, 2012 at 1:52am

Hi Mauricio, Thank you so much! That was very helpful! ;)

Comment by Mauricio P. Montalvo on October 18, 2012 at 10:55pm

Hi! good work.
Try using "wave" component in place of "solid diference" it takes less processing time. You can also try using "fillet"and "scale" for the sizes and the interior sections. greetings :)