Grasshopper

algorithmic modeling for Rhino

Created with the new 'Exoskeleton' tool and Kangaroo

Views: 874

Comment

You need to be a member of Grasshopper to add comments!

Comment by Wiktor Kidziak on October 28, 2013 at 5:47pm

Is there a way to generate mesh from lines to achieve a node type and end connections like the one on the right as opposed to what I am getting at the moment with exoskeleton on the left?

Comment by patric guenther on December 30, 2012 at 2:06pm

@ daniel: could you post the definition? i always have the problem that i get some big artefacts in the mesh....

Comment by RWNB on December 30, 2012 at 1:21pm

thank you, that's promising!

it's nice when there are perspectives. (:

Comment by Daniel Piker on December 30, 2012 at 1:07pm

Hi RWNB -

There's not currently any way to vary the radius across the network directly, but WeaverBird's 'Offset' function allows you to specify different values per vertex.

Here's a wireframe thickened with Exoskeleton, then offset in this way with WB, with some smoothing and subdivision in between:

Comment by RWNB on December 30, 2012 at 11:59am

As always uncatchable!

daniel, ist it possible to work with attractors, to change the radius of the exoskeleton-tool in different areas?

something like this?

http://www.danielwidrig.com/index.php?page=Work&id=Grid

Comment by Navaneeth on December 21, 2012 at 10:27am

Wow, a Radiolarian skelton!!!

Comment by Daniel Piker on December 21, 2012 at 10:26am

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service