make a hole

Comment

Comment by Aurelien Bonvalet on April 23, 2012 at 6:54am

Sorry, I didn't saw that your answered. 

At first yes, that was the premier second edition.

Then I join a picture of a definition, just use a cylinder as a brep.

Does it look of what you expected?

Comment by yahya ibraheem on April 17, 2012 at 5:55am

premier second edition ?

Comment by yahya ibraheem on April 17, 2012 at 5:50am

page not found man 

Comment by yahya ibraheem on April 17, 2012 at 5:09am

no it's not ,, :(

Comment by Aurelien Bonvalet on April 17, 2012 at 3:18am

So? does it work?

Comment by Aurelien Bonvalet on April 16, 2012 at 1:58pm

Try here.

http://www.liftarchitects.com/journal/2009/3/25/the-grasshopper-pri...

Comment by yahya ibraheem on April 16, 2012 at 12:49pm

page not found ...

Comment by Aurelien Bonvalet on April 16, 2012 at 12:32pm

I think for the result you are expecting for, you should inspire from the page 82 of http://www.liftarchitects.com/storage/research/Grasshopper%20Primer...

And you create intersection between your surface and the tube...

Does it help you?

Comment by Nay Soe on April 16, 2012 at 12:00pm

From the way i see it, You'll have to do some work to patch up each surface. The projection will only work in 1 vector I believe. 

Comment by yahya ibraheem on April 16, 2012 at 11:45am

hi , actually i would like to add such a holes to my design here in the attachment , so how can i do that ,, thanks

• ‹ Previous
• 1
• 2
• Next ›
• Page