3D Vornoi Cell Cluster 3d print

Comment

Comment by Anirudh Dhawan on May 13, 2012 at 2:17pm

Hi Ann, 

This prints were done using a zcorp powder process. We liked this method, though its a bit messy, because of the smooth finish.

Comment by arlapka on May 13, 2012 at 9:48am

Hi, Anirudh!

I'm new to parametric modeling, and currently looking into some 3d-printing technologies. I was just wondering if you could advise me what kind of printer did you use to get this quality of surface? 

Would be very gratefull for your advice!

Best regards,

Ann.