Installation problem

Hi:

I installed the package, it creates a folder in C: called SpaceSyntax....., I copied the grasshopper components to the special folder program. but it dosen´t appear any tab or component

I reviewed the components for if those are blocked or whatever. I use Rhino 5 (X64) and the last grasshopper 0.90064

Any solution?

Replies to This Discussion

Permalink Reply by Samane on December 10, 2013 at 5:14am

Hi,

If you have run the installer, you should have a folder containing a GHA file and example files. You can drag and drop the GHA onto your grasshopper canvas. note that you can specify where you want to save that folder while installing. If the problem still exists you can post it in the Space Syntax page.

Permalink Reply by jorge sainz de aja on December 10, 2013 at 6:19am

yes i try to drop the gh flie example into canvas but it send a message saying that it dosn´t recognise the space syntax compoents

Permalink Reply by Samane on December 10, 2013 at 6:23am

which file are you exactly referring to? SpaceSyntax_for_GenerativeDesign or Example_SpaceSyntax_GH

Permalink Reply by jorge sainz de aja on December 10, 2013 at 10:50am

I drop the SaceSyntax_for_GenerativeDesign.gha in the special folder of grasshopper. after closing rhino etc I try to open the Example_SpaceSyntax_GH.gh with the grasshopper but it says that it doesn´t recognise the spacesyntax components

Permalink Reply by Pirouz Nourian on December 12, 2013 at 9:08am

Hi Jorge,

Have you updated your Rhino and GH recently? Did you drop it into the components folder?

You need to make sure your Rhino is up to date; to do so, you can go to Rhino/Tools & Options and check if you have an up to date version. If not you can enable that. Please let us know if the problem still exits.

Permalink Reply by Christopher on April 18, 2014 at 4:12pm