multiple questions

Replies to This Discussion

Permalink Reply by Santiago Garay on September 7, 2021 at 4:10pm

Hi Jihn,

1 - Panel follows surface normals, to reverse panel you have to reverse surface normal (flip).

2- Unfortunately does not support curved panels (It can be done but requires some custom geometry, not straightforward)

3- Depends what are you doing with the geometry, if you export to Lumion, you can probably delete the wall layer there. Otherwise explode the blocks in Rhino and delete the wall layer with its objects.

 4- Here is where the SkinDataViewer component comes handy, you can extract all the glass breps and extract one of the faces only. See below:

Permalink Reply by Jihn Eric on September 7, 2021 at 8:19pm

Hi Santiago,

Thank you so much for your time and clear answers. BTW, sorry for the very newbie question. What is the last component? where to find it? thank you.

Best,

Jihn

Attachments:

• Capture.png, 884 KB

Permalink Reply by Santiago Garay on September 7, 2021 at 8:27pm

Is the item component. You can find it in the sets/list section.

Permalink Reply by Jihn Eric on September 7, 2021 at 8:30pm

Hi Santiago,

I found it, Again thank you so much for your great help. cheers.

Best,

Jihn