Changing the Corner Point to Start Placement of Panels

Hi Santiago,

I would like to ask if there is a method to change the point from which the panels start to be placed. Normally, the point is the left lower corner point (in red) of the surface. Is there a way I can change that point to the left top corner point (in green)? So the empty space stays below the panel not above.

Thanks a lot for your help :)

Bests,

Attachments:

Cornerpoint.jpg, 189 KB
CornerPoint.gh, 66 KB

Replies to This Discussion

Permalink Reply by Santiago Garay on June 16, 2022 at 1:03pm

Hi Usmi,

Unfortunately that option is not supported. Did you try using the DEFAULT VERTICAL SHIFT Skin Generator Option? See the image below, would that do the trick for what you are after?

Permalink Reply by Usmi H on June 17, 2022 at 5:50am

Hi Santiago,

It is working for now but I am trying to get a higher degree of parametrization in case I have more than one panel. I have tried to link it with the generative design node to go through all the distances to position the panels at the top line. But it could be great if there was an in-built option to change the corners of placement. Still, the solution you showed is working great with optimization plug-in.

Thanks again :)

RSS