Grasshopper

algorithmic modeling for Rhino

silkworm and ultimaker2

Curious if anyone is using silkworm and ultimaker2 3d printer together and can share results, advice or settings? Thanks

Views: 851

Replies to This Discussion

Permalink Reply by dajana on December 5, 2015 at 10:33

any answer ? Did you menage ? 

Permalink Reply by Mich on February 28, 2017 at 3:31

Hello, 

Anyone has more information about silkworm and ultimaker 2?

Thanks

Permalink Reply by ashish mohite on April 4, 2017 at 4:51

hi,

I am using it with ultimaker for over 2 months .

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service