list problem, one item to much

Salut,
I have a list problem. There is one item into the list and I don't know where it comes from or even how to kick it out of the list.

Furthermore I am not sure what makes more sense, using the offset and fillet component or better the scale and fillet commands.

Attached is an image with the first problem the second is in the attached definition.

Thanks for your help,

Sebastian

Attachments:

Voronoi_Attractor_Offset_SL_21062012.gh, 18 KB

Replies to This Discussion

Permalink Reply by Danny Boyes on June 21, 2012 at 8:37am

Hi Sebastian,

The 0 offset distances are causing the offset component to place the un-modified cells onto a branch one level above the offseted cells. When you use the List Item component you are then getting this erroneous cell every time.

Here would be my approach using Cull Patterns

EDIT: didn't realise this was in ParametricCamp. Hope it helps anyway.

Attachments:

Voronoi_Attractor_Offset_SL__db.gh, 17 KB

Permalink Reply by Sebastian L. on June 21, 2012 at 8:45am

Hey Danny,
this is a nice solution! Thanks a lot! :)

Permalink Reply by Garcia del Castillo on June 22, 2012 at 4:14pm

Howdy!

Danny is very right, you were generating a lot of new cells that you actually couldn't see because they were 0 offsets and were under previous geometry. You would have to cull out the zero offset cells, like he suggested. Also, find attached another alternative, where you further recycle the distance pattern you generated to avoid having to zero offset cells and then culling them out, to directly just offset what you need.

Thanks a lot Danny, don't worry if this is PC, you are much welcome here! And good work Sebastian!

Attachments: