Grasshopper

algorithmic modeling for Rhino

Radial Pattern

I'm using the panelling tools plugin for rhino. Need a hand with a project im currently working on.

I've been sent this pattern and i need it to flow over a surface in a radial pattern. The problem is the pattern dosnt work as they've sent it, im trying to get it to work as close as possible to what they want.

This is the image they've sent

And this is my attempt.....

as you can see the issue is the centre becoming clustered. is there a way to make it more uniformed without going into a mess in the middle?

Hope this all makes sense.

Thanks

Luke

Views: 1448

Replies to This Discussion

Permalink Reply by Luke Orford on September 12, 2017 at 4:59am

Also you note in there pattern it dosnt actual work either as a radial pattern, so i need to figure out that part aswell!

Permalink Reply by Rajaa Issa on September 12, 2017 at 10:27am

Hi Luke,

Check the example I posted in discourse. It will give you some clues. Let me know if you need more help

https://discourse.mcneel.com/t/custom-paving-pattern-based-on-curve...

Permalink Reply by Rajaa Issa on September 12, 2017 at 10:48am

Here is a scree shot of the modified definition:

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service