Grasshopper

algorithmic modeling for Rhino

ptMorph3D - Pull tolerance

Hi,

For some reason looks like there is a tolerance problem with ptMorph3D with "pull" enabled. I was trying it with different surfaces and tiles and looks like the further away from 0, 0 point the more panels start to flow and distort from the base grid. Could someone check it, and confirm, or anyone knows if there is a workaround? Is that a bug, or tolerance issue? 

Thanks,

Michael

Views: 467

Replies to This Discussion

Permalink Reply by Rajaa Issa on September 7, 2017 at 10:51am

Hi Michael,

Can you share the file with the geometry referenced?

Permalink Reply by Michal Hol on September 7, 2017 at 11:18am

Sure. I tried to replicate it right now. The distortion is smaller (for no reason, as I'm using the same geometry and the same script) but is still there and makes the geometry not interfacing with other parts that I need it to. File tolerance and units are same

Thanks,

Michael

Attachments:
Permalink Reply by Rajaa Issa on September 7, 2017 at 11:43am

You just need to feed bounding surfaces to pull to. See attached file.

Attachments:
Permalink Reply by Michal Hol on September 7, 2017 at 11:59am

Holy cats! Thank you! I don't know why I just ignored it :D

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service