morph 3d mean - "Failed to morph to grid"

Replies to This Discussion

Permalink Reply by Rajaa Issa on August 23, 2015 at 4:15pm

Hi Eran,

Can you share a file or example to show what is not working?

Permalink Reply by Eran B on August 30, 2015 at 5:52am

Hi Rajaa,

Attached, are files of the trials.

In general, the purpose is to transform unit A to unit B in a gradient kind of way (meanSurface) over variable distances.

I succeeded doing it in regular PT (the bodies in grey) but in GH-PT it fails.

The definition is a bit complex, kinda got lost inside it. I even tried going back to rhino for the regular PT but when I try to bake the grid or the surface, I keep getting lots of surfaces or lots of grids.

Thanks in advance.

Eran

Permalink Reply by Eran B on August 30, 2015 at 5:53am

files..

Attachments:

• test.3dm, 1.8 MB
• test.gh, 21 KB

Permalink Reply by Rajaa Issa on August 31, 2015 at 6:22pm

Hi Eran,

The problem is that you subdivided your surface to many smaller ones, then grid each of the small ones. That created so many grids.

Attached is a cleaned up solution. Let me know if it works for you.

Attachments:

• Chain_Morph3DMean.gh, 25 KB

Permalink Reply by Eran B on September 16, 2015 at 6:32am

Hi Rajaa,

Sorry for the late response. work+holidays.

Thank you so much! Your solution help a lot.

I was stuck with this problem for almost a month.

I wasn't familiar with the command Surface Parameter. It's brilliant.