Delay in Simulation...

I repeatedly tried several times to run a test simulation for a small 3*3*3 meters room, as shown in the attached files below, in order to determine the SPL. However, running a simulation takes a long time and can take up to 20 hours each time. Please take a look the files below and connect the polygon surface to the room (the incomplete battery connection), and let me know which set i had a problem with.

Attachments:

room test.3dm, 65 KB
Room test.gh, 19 KB

Replies to This Discussion

Permalink Reply by G.C.Ruvio on October 17, 2021 at 3:45am

Hallo Tarek,

I looked at your script and made some changes. What you see allows you to better read the layers from Rhino. Importantly, each Layer must be named with a number, followed by an underline, and the nomenclature must not have empty spaces (per example: 5_CladdingWood).

Leaving the absorption coefficient that you set yourself, it actually gave problems, because they were inadequate, especially the Floor and ceiling layer. As Arthur says, having no absorbent materials lengthens the simulation a lot.

Some advice,
review the absorption coefficient, give a appropriate scattering to the type of surface and try to direct the Rhino surfaces correctly. Those of your model all looked outwards.
I hope I was helpful

Room%20test_re.gh

Permalink Reply by Tarek Kamel on October 18, 2021 at 12:10am

I am really thanks a lot for yr reply. But, can u upload the Rhinoceros file too, inorder to let me see the exact difference between mine and yr file...

Permalink Reply by G.C.Ruvio on October 18, 2021 at 12:48am

Hallo Tarek,

I have attached the Rhino file

room-test_re.3dm

Permalink Reply by Tarek Kamel on October 20, 2021 at 3:21am

many many many many many Thaaaaaaaaaaaaaaaanxxxxxxxxxx

RSS