Grasshopper

algorithmic modeling for Rhino

Unable to use laybug component!!!!

the fail laybug component window is always pop up!
what should i do?
THX

Views: 137

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Abraham Yezioro on April 21, 2015 at 10:32am

Did you installed the Python component?

-A.

Permalink Reply by Mostapha Sadeghipour Roudsari on April 21, 2015 at 11:34am

Also you have duplicated components. You can read how to remove current installation if you check the group page.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service