Grasshopper

algorithmic modeling for Rhino

Radiance Materials outputs problems

Hello Mostapha,

I am trying to understand few things regarding the Radiance custom made materials.

1) Metal: Shouldn t the specularity be above roughness in the inputs? The output comes out that way anyways.

2) transMaterials: Should the sequence follow that sequence? 7 red green blue spec rough trans tspec?

I get output number different from the inputs as seen in the attached.

Thanks,

dimitris

Views: 252

Attachments:

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Mostapha Sadeghipour Roudsari on July 24, 2015 at 10:40pm

Hi Dimitrios,

1. The output is correct and specularity comes first (http://www.artifice.com/radiance/rad_materials.html). The order was a user interface decision and since we have it like this in all the other components I would leave it as it is.

2. It's a bit more complicated. You can read more here (http://radiance-online.org/community/workshops/2010-freiburg/PDF/Da...). Orn also made a good description based on this presentation (http://www.grasshopper3d.com/group/ladybug/forum/topics/radiance-bl...).

Mostapha

Permalink Reply by Dimitrios Papadopoulos on July 28, 2015 at 3:05pm

Thanks!

Dimitris

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service