Grasshopper

algorithmic modeling for Rhino

Question about example file: 006_annualDaylightAnalysis_I_gettingStarted.gh

Dear all,

For some reason I'm getting an error message when I open example file 006_annualDaylightAnalysis_I_gettingStarted.gh when I run it (and using a simple box which I've set as a brep. The Honeybee Run Daylight Simulation component gives the following message: "Can't find the results for the study", please see the image attached. I'm probably making a mistake, can you advise me what I'm doing wrong?

best,

Kevin

 

Views: 204

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Mostapha Sadeghipour Roudsari on June 23, 2014 at 5:29pm

Hi Kevin,

Simulation fail to run on your system for some reason. I assume you see cmd windows pop up and close pretty fast. Let's start from the most basic reason that can cause this.

Do you have Daysim installed and if yes where do you have it installed?

Thanks,

Mostapha

Permalink Reply by Kevin on June 24, 2014 at 4:27pm

Hi Mostapha,

Thank you for your answer, this solved the problem, I was under the assumption that I could run it on radiance alone,

kind regards,

Kevin

Permalink Reply by Claudio on June 23, 2014 at 6:49pm
Hi Kevin I came across that error message while not,having enough points on the genpts component.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service