LADYBUG Error. please help to solve

Replies to This Discussion

Permalink Reply by Mostapha Sadeghipour Roudsari on February 25, 2017 at 3:58pm

1. Remove the current installation: http://hydrashare.github.io/hydra/viewer?owner=mostaphaRoudsari&...

2. Make sure you have GHPython installed and the GHA file in unblocked.

3. Install Ladybug + Honeybee!

Permalink Reply by Ana Sidorova on February 25, 2017 at 4:26pm

installed GHPython now will try to remove the installation. will try, thank you again

Permalink Reply by Mostapha Sadeghipour Roudsari on February 25, 2017 at 4:33pm

The definition that removes installation is using GHPython. I should have changed the order between 2 and 1.

Permalink Reply by Ana Sidorova on February 25, 2017 at 4:56pm

this is what i am getting now.please help

Attachments:

• error.jpg, 486 KB

Permalink Reply by Ana Sidorova on February 25, 2017 at 4:57pm

but i did remove as per instructions

Permalink Reply by Mostapha Sadeghipour Roudsari on February 25, 2017 at 5:28pm

Just select Replace All. That shouldn't make any issues for running ladybug and honeybee.

Permalink Reply by Ana Sidorova on February 26, 2017 at 5:49am

All works thank you :) do you know much about CDF- Fluid dynamics- to try air flow ?

Permalink Reply by Ana Sidorova on February 26, 2017 at 9:09am

Hi, out of curiosity why i dont see colored chart and model on my side. i am following your youtube video(which is great) :) may you advise please?

Permalink Reply by Mostapha Sadeghipour Roudsari on February 27, 2017 at 7:37am

you need to turn of the preview of the components in Grasshopper, and also hide the geometries in Rhino.