Grasshopper

algorithmic modeling for Rhino

LABEL ZONES IN HONEYBEE ERROR

Hi

I'm experiencing the following error using Label Zones and Label Zone Surfaces:

Solution exeption: name: 'W' is not defined

this notification appears on both the commands as i place them on the canvas

Any idea??

I've Rhino GH and HB updated.

Thank you for your help

Views: 219

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Devang Chauhan on May 27, 2017 at 1:31am

Hi,

Please also put Ladybug_Ladybug on the canvas and recompute. That should make the error disappear.

Permalink Reply by giuseppe ridolfi on May 27, 2017 at 1:53am

Thank you so much

 I don't have any idea why,  but suddenly it started to work .

Maybe you are right because  in the different things i tried,  I put Ladybug on canvas as well but I didn't remember the precise  moment when it started to work 

SOLVED

Permalink Reply by Devang Chauhan on May 27, 2017 at 2:37am

A lot of functions in Honeybee use classes in Ladybug. Therefore always keep LB and HB both on the canvas for any Honeybee simulations.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service