Grasshopper

algorithmic modeling for Rhino

Installation problem

Hello Everyone,

I have Honeybee and Ladybug installed on one computer and they work fine. I tried to install them on another computer and I get the message shown in the picture below. Any suggestions.

Rania

Views: 224

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Mostapha Sadeghipour Roudsari on March 8, 2015 at 6:21pm

Hi Rania, Make sure GHPython is installed correctly on your system and is working fine. This page may help: http://www.grasshopper3d.com/group/ladybug/forum/topics/ladybug-ins...

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service