Grasshopper

algorithmic modeling for Rhino

Idf creation with honeybee, error in file writing

Hi comunity!

I'm new here and I've got some trouble using Honeybee to create an idf Energy Plus file.

In particular after I've set all the materials and all the Epconstruction, write them on the EPlibrary, createHBSrfs and finally create the thermal zone with comand createHBZones, when I try to write the idf file with runEnergySimulation during the execution of the program some errors occurs:

I don't know why honybee doesn't find the library that I've previously upgraded with my material.

I attach my Rhinocerons file with the geometry and the Grasshoper file that i've created.

Thanks.

Gianluca

Views: 452

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Devang Chauhan on July 19, 2017 at 4:16pm

Hi,

Please make sure there are no unnecessary spaces in the text panels. This was changing the way materials are being written in Honeybee.

In the .gh file, please open Screed_41cm in both the cases and observe the cursor to see the difference. This was causing the key error.

-Devang

Attachments:
Permalink Reply by Gianluca Pilati on July 20, 2017 at 2:35am

Ok, now all works, thank you for your fast and accurate answer!!

Gianluca

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service