Daylight Factor Values error (?)

Replies to This Discussion

Permalink Reply by Mostapha Sadeghipour Roudsari on August 23, 2014 at 10:18am

Hi Dimitris,

This is a light leakage which is common if parameters are set lower than what it needs to be. Honeybee by default checks the inputs for parameters and set them to an acceptable minimum but looks like it wasn't enough for this case. I used a higher quality [1] for radParameters and the results looks fine.

In the current version the parameters are set based on meter units. What was the units in your document?

Permalink Reply by Dimitrios Papadopoulos on August 25, 2014 at 8:56am

Hello Mostapha,

Understood.

Thanks a lot!

The units are also meters in my document.

Dimitris