Butterfly Block Mesh error

Hi,

Thanks for this awesome work.

I've been following this discussion and decided to open a new one so issues don't get lost.

I followed Mostapha's advice there and replaced the runmanager.py as instructed.

Now i'm getting the attached error.

I'm using both Outdor_airflow and HumanUI_OutdoorCFD examples.

Any recommendations?

Thanks,

-A.

Attachments:

Capture.JPG, 175 KB

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Mostapha Sadeghipour Roudsari on August 23, 2016 at 4:36pm

Hi Abraham,

Great to know! I added the link to the page.

'Load Probes from Project' should load the results for you without re-running the analysis.

Are you connecting the readMe output from simpleFOAM to a panel? It prints so many lines and that can slow down GH.

Mostapha

Permalink Reply by Abraham Yezioro on August 23, 2016 at 11:29pm

Hi Mostapha.

Loading results works fine.

I disconnected the panel from the simpleFoam and now the slowness is fine.

A couple of questions more:

I get results for each 100 iterations. Can i see them?

I don't succeed to see the mesh. I follow the instructions on the Getting Started page but in each try the mesh and pts outputs are null for the loadMesh/Pts components.

Thanks,

-A.

Permalink Reply by Abraham Yezioro on August 24, 2016 at 1:29am

Ohhh. It is going to be painful :-)

I managed to see the mesh and points. What happened is that i asked to compress the results before writing them. The component doesn't know how to read the compressed files. Though the results themselves can be compressed and represented.

-A.

Permalink Reply by Mostapha Sadeghipour Roudsari on August 24, 2016 at 8:04am

Hi Abraham,

Thank you for reporting back. Butterfly should be able to unzip and visualize the results if they are zipped. I add an issue to github:

https://github.com/mostaphaRoudsari/Butterfly/issues/56