Karamba3D Discussions (725)

Sort by:

Discussions	Replies	Latest Activity
Optimize cross section - Beam sets Hi. I am trying to work with the optimizeCrossSection algorithm. I want beams to have the same cross section throughout the whole length. F… Started by Rasmus Holst	7	Aug 12, 2013 Reply by Rasmus Holst
node_numbers Hi guys, just a small question.i'd like to transport a beam structure to sofistik for further examinations. the nodes and their position ar… Started by Ole Ohlbrock	0	Jul 30, 2013
MaxDisp during CrossSection-Optimization Hi guys @ karamba, the crossSectionOptimizer module is really helpful. I think i roughly understand the algorithm behind;)the only question… Started by Ole Ohlbrock	9	Jul 27, 2013 Reply by Ole Ohlbrock
Grasshoppers not reacting after selecting LC Hi guys, It's just a small problem, but still nerving.Always when i select a new/another loadcase in the modelview component..gh "locks"--&… Started by Ole Ohlbrock	4	Jul 5, 2013 Reply by Ole Ohlbrock
Custom Beam Cross Section Hi there, does anybody know of a way to define a custom beam cross section by specifying A, Iy, Iz, ..., rather than choosing one of the p… Started by Stefan	1	Jun 30, 2013 Reply by Karamba3D
making a range out of item list to be selected for optimization (Karamba Best Support Position Effort) Hey all, immediately with no introduction but respectfully, i wana calculate optimized support position on a supposed waffle ceiling, adapt… Started by Mahdi Soheyli Fard	0	Jun 28, 2013
ShellView strange values Hi all, I'm trying to understand the tension values coming from the shellview cluster of my model, but I'm getting very weird values ( KN/c… Started by Luís Carvão	0	Jun 25, 2013
Grasshopper crashes when I try to use some options Hi! I am using the version 1.0.3 of Karamba with Rhinoceros 5.0 64 bit and Grasshopper 0.9.0056. All work fine but I have some problems whe… Started by Jose M. Ortolano	1	Jun 20, 2013 Reply by Karamba3D
Analyse component returns NaN (but is not red) Hello, The model which is in attachment shows an NaN output at the Analyse component. Is this the same as if the component would turn red… Started by Lara Alegria Mira	12	Jun 18, 2013 Reply by Lara Alegria Mira
Print Karamba model with load values Hi, I am trying to print an image of the model showing the load values, but the size of the numbers is too small to be read. If I use the t… Started by Mira Conci	1	Jun 16, 2013 Reply by Karamba3D