Karamba3D Discussions (725)

Sort by:

Discussions	Replies	Latest Activity
Providng scissor type hinge joints in Karamba between continous memebrs Hello, I am very new to Karamba. I am working on design and analysis of a timber gridshell using Kangaroo and Karamba. I need to provide sc… Started by Anand Shah	4	Jan 15, 2018 Reply by Anand Shah
Point load placement in Karamba Hi For a simple test, i applied point loads to a simple 'tent' structure. I've put a list of the points into the 'Loads'-element, but if I… Started by Reinout van Arnhem	1	Jan 9, 2018 Reply by Karamba3D
Analyze solids Hi, A few friends and I, recently started modelling a bench made out of concrete (GRFC concrete). The legs of the bench are circular and an… Started by Tsvetan Donov	1	Jan 8, 2018 Reply by Karamba3D
Beam Optimization Hi, I am new to Karamba and Grasshopper, so I am basically copying all tutorials I can find on youtube. I did a simple cantilever beam with… Started by Tsvetan Donov	2	Jan 8, 2018 Reply by Tsvetan Donov
Shell Analysis Hi all, I've been trying to analyze a shell but i am not sure about the load condition, because i wanted to give a uniform load to the whol… Started by Davide Rando	1	Dec 22, 2017 Reply by Joseph Beard
material utilization - mesh resolution + model view Hello, I am working on a model of concrete building containing of slabs (shells) + columns and beams (beams). I have two questions regardin… Started by Wujo	2	Dec 20, 2017 Reply by Karamba3D
Cantilever element Hi Could you help me please; I have a doubt about my modeling. I have element in aluminum recessed on one side and loaded on the other. I… Started by sandra	1	Dec 19, 2017 Reply by Karamba3D
Large deformation analysis with cable-like elements Hello, I'm using the LaDeform component to approximate large-deformation behaviour of a tensile membrane with cables. Unfortunately, my a… Started by Lucas Epp	3	Dec 15, 2017 Reply by Karamba3D
pattern hinges karamba Hello all, I am trying to make a beam grid that is connected as shown in the picture. There are no primary and secondary beams, but they… Started by popi papa	7	Dec 14, 2017 Reply by Matthew Tam
bending moment changes according to the size of cross-section? Hello all, I made a simple vertical structure, and set supports at the top and bottom points. bottom : rigid connection; all blocked top… Started by Jaeman PARK	11	Dec 12, 2017 Reply by popi papa