Karamba3D Discussions (725)

Sort by:

Discussions	Replies	Latest Activity
Windload as a line load. Hiya, In my model I've defined the wind loads as uniform line loads (it's an unclad structure and I want the load to only apply to the mem… Started by nicebikemate	1	Jan 28, 2018 Reply by Karamba3D
Where does the horizontal force comes from Hi, I tried to make a truss in Karamba, but it gives me a horizontal force, while i have mad the supports as fixed supports. And the other… Started by Giorgio	11	Jan 26, 2018 Reply by Joseph Beard
Multiple Rigid Body Mode Hi ya, I'm getting this error in my model. I understand that it relates back to multiple nodes being created, but I'm unsure what to do ab… Started by nicebikemate	1	Jan 25, 2018 Reply by nicebikemate
meter vs millimeter I wan't to have my design model in mm and structural model in meters in the same GH file. So does the scale set in the rhino file affect t… Started by tim sullivan	2	Jan 23, 2018 Reply by tim sullivan
Shell Wind Analysis Hello Clemens, I am running into an issue: I need to perform an analysis on a surface that will be an installed pavilion on a beach. I op… Started by Bradley Bowers	1	Jan 23, 2018 Reply by Karamba3D
Verifying results Hi For my thesis project I am optimizing a folded steel plate structure in Grasshopper. For the structural calculations I use Karamba. Ev… Started by Reinout van Arnhem	5	Jan 19, 2018 Reply by Karamba3D
HOW TO ADD A SUPPORT IN THE MIDDLE OF THE BEAM HI If i want to add a support in the middle of the beam, i dont know how does it works. Started by CHILEMENI	2	Jan 18, 2018 Reply by CHILEMENI
Providing memeber cross section in karamba and comparison of modelled results with actual strucutre. Hello, This is my first educational project on Karamba, therefore some questions are very basic so please pardon me for that. 1. I am work… Started by Anand Shah	0	Jan 15, 2018
Providng scissor type hinge joints in Karamba between continous memebrs Hello, I am very new to Karamba. I am working on design and analysis of a timber gridshell using Kangaroo and Karamba. I need to provide sc… Started by Anand Shah	4	Jan 15, 2018 Reply by Anand Shah
Point load placement in Karamba Hi For a simple test, i applied point loads to a simple 'tent' structure. I've put a list of the points into the 'Loads'-element, but if I… Started by Reinout van Arnhem	1	Jan 9, 2018 Reply by Karamba3D