Karamba3D Discussions (725)

Sort by:

Discussions	Replies	Latest Activity
How to best define a mesh for the transmission of a wind load to facade nodes? Hi again, I am currently trying to apply a wind load to a portion of a buildings facade. I have determined these nodes by applying the sa… Started by Nathan Stuckey	8	Jul 14, 2018 Reply by Nathan Stuckey
Measuring units Karamba to IFC Hi, I have a question about Karamba. I want to use Karamba and make IFC files from it after the structure is done, but i know Karamba meas… Started by Giorgio	1	Jul 12, 2018 Reply by Karamba3D
Extreme, "rogue", load values when applying wind load to tower as a mesh load? Hi again, On a simillar topic to my recent post, I'm struggling to model a wind load. The façade points/nodes on which the wind acts are… Started by Nathan Stuckey	3	Jul 10, 2018 Reply by Karamba3D
Is it possible to simulate dynamic wind pressure acting on a tower with Karamba? Hi all, Currently working on my master thesis, I have been applying wind loads to tall (100m) slender (+/- 35m x 20m in plan) buildings i… Started by Nathan Stuckey	2	Jul 9, 2018 Reply by Nathan Stuckey
Different displacement constraints for each load case in Cross section optimizer Is it possible to have a different max displacement constraint for each load case while using Cross section optimizer in Karamba? Started by Jay	1	Jul 8, 2018 Reply by Karamba3D
error in point load input: couldn't find the node Hi, I need to add a uniform pressure along the ring circle, but there is no option for this. Therefore I divided the circle and create a se… Started by Jing	2	Jul 8, 2018 Reply by Jing
How to make a joint for beams if there are beams on both sides of an column? Hello, I am trying to make an structure in Grasshopper and I want to analyse the structure with Karamba. I know that Karamba needs to have… Started by Giorgio	5	Jul 5, 2018 Reply by Giorgio
Stress ratio Dears， How to calculate the stress ratio of a structure？ thank you！ Started by albert	1	Jul 3, 2018 Reply by Karamba3D
von Mises stress deviation in shells For verification purposes in designing a large concrete dome I've compared the von Mises stress between the Karamba Utilization component (… Started by Reese	1	Jul 2, 2018 Reply by Karamba3D
karamba.dll 1.3.0 does not contain a managed assembly. Dear all, I'm building a Grasshopper plugin in Visual Studio that fetches information from the karamba model that is set as an input of a… Started by Lennert Loos	2	Jul 2, 2018 Reply by Lennert Loos