Voronoi in Karamba

Replies to This Discussion

Permalink Reply by yousef anastas on December 4, 2014 at 6:04am

Hi Llordella,

As I understand your problem, you need to have common nodes defining your slabs, your columns and your voronoi facade.

Best

Permalink Reply by Llordella Patricio on December 4, 2014 at 7:07am

Hi, yes, I'm working on it. Which is not the way to do it, I think there are two alternatives:
1- Build the building and then apply the Voronoi (the problem is not how to choose the points of the segments of the beams to create the Voronoi these points)

2- Building the Voronoi and build those points beams and columns (the problem is as simple select a Voronoi edges)

I hope you understand my question.

Thank you
Best

Permalink Reply by yousef anastas on December 4, 2014 at 7:33am

Sorry I'm afraid I do not understand.

I believe the way to do it is to define the whole geometry and then :

-Divide the columns at each intersection point with the Voronoi.

-Create a mesh for your shells with points that are common with the Voronoi.

Best

Permalink Reply by Patricia Edith Camporeale on December 9, 2014 at 5:05am

Hi, I´m working together with Llordella. Our matter is how to extract the edge points of the Voronoi surface.

We need help.

Thanks in advance.

Patricia

Permalink Reply by Ramon on December 12, 2014 at 8:50am

extract the edges of your innitial srf4pt. do so by wireframe brep. intersect the resulting curves with each one of your vornoi branches.

Permalink Reply by yousef anastas on December 12, 2014 at 9:08am

I don't know if that helps but you have components in kangaroo, like naked vertices that will help you select the boundary points of a mesh, if that's what you're trying to do.

Permalink Reply by Patricia Edith Camporeale on December 17, 2014 at 1:50pm

Thanks Yousef, I worked it out!

Permalink Reply by Patricia Edith Camporeale on December 17, 2014 at 1:50pm

Thanks Ramon, I worked it out!