Grasshopper

algorithmic modeling for Rhino

mesh loads

when I add a mesh load how is it measured? What is the default mesh load ? If I increase the load through an amplitude on the vector before the mesh load component it multiplies the load by this number, correct? Thanks

Views: 255

Replies to This Discussion

Permalink Reply by Karamba3D on July 30, 2015 at 2:02am

The physical unit to be supplied at the MeshLoad is kN/m2 in case of SI units (see manual; it's also mentioned in the comment which appears when you let the mouse pointer hover over the corresponding input-plug). There is no default value. The load is defined by the direction an length of the vector you feed into the 'Vec' input-plug.

Best,

Clemens

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service