Mesh Load Unit Question

Hi,

I have a question about the mesh load unit. It seems Karamba only extracts values from Rhino, not the unit. For example, I work with [mm] in Rhino and I have a surface of 1000000[mm^2]. When I assign this surface to the mesh loads component, the area given by Karamba is 1000000[m^2], but it should be 1000000[mm^2]. When I work with [m] in Rhino, the unit in Karamba is correct. I wonder if I have to work with [m] in Rhino to get the unit right in Karamba? Is there any way to control the unit manually in Karamba?

Regards,

Aslinn