Grasshopper

algorithmic modeling for Rhino

Pull to curve - Iterative

Hi.

Is it possible to add a attraction power between to curves? Not with a spring at a specific point, but more en general? So that the two curves will stick to eachother at what intersection point is most convenient.

Like bending to rods and the one "below" will hit the one up "higher" and can not move anymore. 

I hope that it makes sense, otherwise I will try explain again.

Best regards Rasmus

Views: 396

Replies to This Discussion

Permalink Reply by Daniel Piker on December 18, 2012 at 2:42pm

Yes, this makes perfect sense and is something I'm already working on - it will be in the next release!

(and also collisions between line segments)

Permalink Reply by Rasmus Holst on December 19, 2012 at 1:52am

Sounds nice Daniel. Looking forward to the next release. Do you know if you will be implementing material properties as we talked about? 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service