Kangaroo paneling problem

Hello there, i have a little problem whit Kangaroo.I got Kangaroo Physics 099, and uploaded the user's object, but the software show me only some command located under the utility panel. I use Grasshopper 0.9.0076. Have you some hint or solution?

Attachments:

kangaroo_support-1.jpg, 420 KB

Replies to This Discussion

Permalink Reply by ng5 Alex on July 17, 2017 at 5:17am

Hello bbdick,

make sure the dlls that come along with kangaroo gha are unblocked. youhave to right click/properties them and unblock in case they are blocked.

best

alex

Permalink Reply by bbdick on July 17, 2017 at 5:26am

Thank you so much Alex. I had already checked and it looked ok. The problem is that I can not see the other tools.

Permalink Reply by ng5 Alex on July 17, 2017 at 8:11am

it looks like you have copied the user objects right. are you sure the dlls and kangaroo gha files are in components folder and not in user objects folder?

generally green gha files and dlls go to components folder and yellow ghuser files go to user objects folder.

Permalink Reply by bbdick on July 17, 2017 at 9:02am

Yes i'm sure ;)

Permalink Reply by bbdick on July 17, 2017 at 10:19am

Problem solved. I had restart rhino. Thanks again

Ciao

Permalink Reply by ng5 Alex on July 17, 2017 at 10:27am

ah yes restarting is essential too. in case you dont want to quit rhino there is also GrasshopperUnloadPlugin command that exits gh only

RSS