Grasshopper

algorithmic modeling for Rhino

Equalize Angles Component

Hello,

Is the EqAng component working as intended?

I'm trying to optimize a long chain of springs, so that every segment is bent with the same angle (for manufacturing purposes), without knowing what the "best" angle is:

The way I understand the component is:

1,2,3 (1=start,2=peak, 3=end) for every angle, right?

1x Springs + 1x EqAng Force.

But it's not doing anything. What am I missing?

Thanks. :)

Views: 855

Replies to This Discussion

Permalink Reply by Daniel Piker on August 6, 2014 at 3:58pm

If you post your definition I can take a look at what is going wrong.

Also - if the segments are the same length and in the absence of other forces, EqualizeAngles will just make your curve into a segmented arc, which could be drawn in easier ways without Kangaroo. Am I missing something?

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service